FSL Rose Napkin Holder

FSL Rose Napkin Holder is a set of 3 freestanding lace machine embroidery designs.
The parts of this napkin holder are embroidered in the same way as our FSL ornaments, so the General Guidelines on how to embroider FSL designs might be helpful.

Some points to remember from the General Guidelines:
Use Vilene water soluble stabilizer;
Use the same thread for the needle and bobbin to get two-sided embroidery.
DO NOT embroider several designs in one hoop.

Step One: Embroider the designs on water-soluble Vilene stabilizer; rinse the stabilizer and leave flat to air dry. Take care of the bottom - spread it gently while still wet. When the parts are dry, press them with steam.

Step Two: Take the bottom and cover it with the right panel of the napkin. Align the edges and zigzag them together over the edge with invisible thread.

Step Three: Unfold the right panel and place the left panel over the bottom. Align the edges and zigzag them together.

Step Four: Unfold and lace with a satin ribbon.