Cutwork Lace Applique Daffodil Panel

The Cutwork Lace Applique Daffodil Panel design is available in 3 sizes: for large (5" x 7") hoops, for mega and for commercial-size hoops. Please see the sizes of the design below.

Large Hoop:
Size: 91 x 179 mm
Stitches: 43 230
Colors: 1
Stops: 4

Mega Hoop:
Size: 133 x 258 mm
Stitches: 69 779
Colors: 1
Stops: 4

Commercial Hoop:
Size: 154 x 299 mm
Stitches: 84 733
Colors: 1
Stops: 4

To embroider the design, you will need base fabric, fabric for applique, water soluble mesh and embroidery threads. Select the colors of the fabrics and threads to your taste.

We recommend to use water-soluble mesh, such as Vilene. Vilene D0102 is a non woven dissolvable stabilizer which is imported into the US, is sold in large rolls and is sometimes repackaged under different brand names.

Some of these brand names are Fabri-Solvy by Sulky, Avalon Plus by Madeira, Wash-Away, and Aqua Magic.

40-weight embroidery polyester threads are preferred for the project.
Cotton thread is not suitable because the embroidery will be too bulky.
Rayon thread is softer and sensitive to the chemicals in the water-soluble mesh. We do not like to use rayon thread for cutwork lace projects, though other people do and get good results.

Please note: ALWAYS make a test stitch-out on scrap before you make a stitch-out on the real item.

Step One: Hoop the base fabric with a layer of water soluble mesh. Upload the file into your machine. Start embroidering. The first color will embroider the outline of the frame and leaves.

Step Two: Cover the outline with a piece of applique fabric.
Start the machine. The second color will embroider the outline of the leaves over the applique fabric.

Step Three: Take the hoop from the machine and with a pair of sharp scissors cut away the applique fabric around the leaves outline.

Step Four: Return the hoop to the machine and start it. The third color will embroider the outline of the flowers and stop.

Step Five: Cover the outline with applique fabric and start the machine. It will embroider the same outline over the applique fabric.
Take the hoop from the machine and cut away the applique fabric around the flower outlines.

Step Six: Return the hoop to the machine. The next color will embroider the outlines of the flower centers.

Step Seven: Cover the outlines with applique fabric. Start the machine. It will embroider the same outlines over the fabric.

Step Eight: Cut away the excess fabric around the outlines.

Then cut away the base fabric inside the frame in the areas shown on the picture below:

Step Nine: Return the hoop to the machine and start it. The last color will finish the raw edges of the applique and make the frame and mesh inside the frame.

Step Ten: Wash away the stabilizer and leave to air dry. Press with steam if needed.

Happy Embroidering!